NudgeYour own backend
Set up your Nudge workspace
Checking where you are…
Sign in with the Google account you signed up with. We check it against the approved list, then walk you through the rest. It takes about fifteen minutes, most of it waiting for the install.
Not signed up yet? Ask for access. How it works, start to finish: your own backend.
You're on the list. We read every request ourselves, and we'll email the moment yours is approved. Nothing else to do until then.
Signed up with a different address? Sign out below and sign in with that one.
We couldn't check the approved list just now. That's on our side, not yours.
How do you want to set it up?
Connect your agent
Add Nudge's setup connector to Claude Code or Codex, then give it the prompt at the bottom. The agent can do everything except two clicks that have to be yours: signing in with Google (done, that was this page) and approving Nudge in Convex. When it gets there, it gives you a link to open. More on the agent door.
The key inside these snippets is your sign-in. Keep it to yourself: anyone holding it can act on your setup until it runs out, seven days after you signed in. Sign in again for a fresh one.
Claude Code, one command
Claude Code, or a project's .mcp.json
Codex, in ~/.codex/config.toml
Then tell it
Set up my Nudge workspace: check status, name it, tell me the link to connect Convex, then install and configure Retell
The steps below follow along as the agent works, so you can watch from here.
Your steps
-
1
Name your workspace
-
2
Connect Convex
- Create a free Convex account at dashboard.convex.dev, or sign in if you have one. Convex bills you directly; we charge nothing for running on your own backend.
- Come back here and click Connect Convex. Convex asks which project we may use: create a new one, call it Nudge, and approve.
- You land back on this page with the project connected, and we install Nudge into it next.
Waiting for Convex. If you closed that tab, or it's been a while, start again.
-
3
Install Nudge
Nudge puts its code in your project, sets up sign-in, adds a starter kit and creates your address. It takes a few minutes. You can close this page and come back; the install carries on.
-
4
Open your workspace
Your workspace is ready. Sign in with the same Google account, . You're its first admin, so the invites are yours to send.
The Getting started card inside walks you through Retell, a number, email and your team. Help for each: calls, email, bringing contacts in.
Signed in as ·